Cm9700-cc1 user manual

N O T I C E. The CMKBD/CMKBR that has been shipped to you is configured for use with a CMCC1. running software version DIP switch 7 on the KBD/KBR is set to the ON position. If you need to use the KBD/KBR with a CC1 running software version , set DIP switch 7 to the OFF. Manuals Affected CM, CM-F, CM-C Manual Update The front and rear mounting rails and the mounting brackets are no longer supplied with the CMCC1. Disregard the CMCC1 mounting information in the above referenced manuals. The CMCC1 has been replaced with the CMCC1 and the CMMGR management software has been replaced with the CMMGR management software. MODELS CMKBD Programmable keyboard; VAC, 60 Hz CMKBR Same as CMKBD except rack mountable. CM-C (10/05) 11 TOP VIEW Figure 2.

The front and rear mounting rails and the mounting brackets are no longer supplied with the CMCC1. Disregard the CMCC1 mounting information in the above referenced manuals. To mount the CMCC1 into a standard inch EIA rack follow these instructions: 1. Insert the CMCC1 into the rack. 2. Keep the following in mind when referring to the instructions contained in these manuals: • The CMCC1 contains the latest CC1 software (version or higher), and is programmed with the new CMMGR management software. • Despite the difference in model numbers, the CMCC1 functions the same as the. The CMKBD/CMKBR that has been shipped to you is configured for use with a CMCC1 running software version DIP switch 7 on the KBD/KBR is set to the ON position. If you need to use the KBD/KBR with a CC1 running software version , set DIP switch 7 to the OFF position.

Manual Control of Diagnostic Monitor and Keyboard Allows switch that monitors the status of an active CC1 in a Series system. system user. User Manual: Pelco System to the manual. Unpacking the CMCC1; Unpacking the CMMXB. Installing the CMCC1 Controller. Multiplexers Installation/Operation Manual for detailed camera connection instructions. The following connection instructions refer to the CMCC1;.