1771-oa manual

The OA module uses the WA field wiring arm which has a wiring screw torque of 7 to 9 pounds on an inch. Additionally, the OA uses keying pins between 4 and 6 and 12 and 14 and uses a fuse rated 2 Amps, Volts%(14). Description: The Allen-Bradley OA is an AC output module from the product bulletin. It has Eight (8) Discrete output channels that delivers VAC nominal output within voltage range of VAC, Hz with continuous output current of A per module.5/5(12). The OA module is a modular component of the I/O system requiring a properly installed system chassis. Refer to publication IN for detailed information on acceptable chassis, proper installation and grounding www.doorway.ru: Allen-Bradley CP1.

The OAD Series B module is compatible with all chassis except A1, A2 and A4 chassis. Make sure no other output module or single card block transfer module is placed in the same module group when using 2-slot addressing. Any discrete input module may be used within the same module group. OA, OD or OP) to directly drive terminals on an AC/DC (V) Input Module (cat. no. ID) (Figure 2), but you must connect a K ohm, 10W resistor between the output terminal and L2 (common) as shown in Figure 2. You can use an AC (V) output module (OAD) to drive the ID module without using a resistor. The OA module is a modular component of the I/O system requiring a properly installed system chassis. Refer to publication IN for detailed information on acceptable chassis, proper installation and grounding requirements.

17 l capacity; Manual control; Microwave power output W; 30 minute timer; Defrost function; 6 power settings; Turntable Ø mm; End cooking signal. Hardy Instruments hopes that this manual meets your needs for information and operation. Your module receives its power through the I/O. Allen-Bradley OA PLC-5 Digital Output Module, (8) V AC Digital Outputs, General Purpose, Operating Voltage: V AC; Wiring Arm: WA.